5
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Installing a Wilson Electronics Signal Booster
Select a location to install the Signal Booster that is away from excessive heat, direct
sunlight, moisture and that has proper ventilation. Ensure the Signal Booster is installed
within six feet of where the cell phone or cellular data card will be used (to accommodate
the six-foot adapter extension cable). Run the cable from the Outside Antenna and attach
it to the connector labeled “Outside Antenna” on the Signal Booster. Connect the AC/
DC power supply (sold separately) to the power input labeled “DC 12 V IN” on the Signal
Booster.
Recommended installation locations for
in-building are:
• On a wall
• On the ceiling
• Near a power outlet
In-Building
Installing a Wilson Electronics Outside Antenna – In-Building
Select a location on the roof of the building to install the outside antenna that has the
most unobstructed line of sight to the cell tower. Follow the specific antenna installation
instructions included with the outside antenna. Lightning protection is recommended for all
in-building installations (sold separately). Take extreme care to ensure neither you nor the
antenna come in contact with any electrical power lines. A Yagi antenna must be installed
horizontally with the elements vertical and the drip hole on the bottom. Ensure there
are three feet of clearance in all directions surrounding the antenna. To obtain maximum
performance, the antenna should point toward the cell tower. Follow the instructions
included with the outside antenna.
Warning: The outside antenna must be installed
on an outdoor permanent structure with a
separation of at least 20 feet from all persons
during normal operation.
!
Commentaires sur ces manuels