Wilson Electronics AG Pro 70 Spécifications télécharger pdf (Page 10)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Powering up a Wilson Electronics

Signal Booster

1. Never point the front of a Directional Outside Antenna toward the Inside

Antenna. See Figures 1 & 2 on page 10.

2. Ensure that both the Outside Antenna cable and the Inside Antenna cable

are connected to the Signal Booster and the connections are tight

before powering up the Signal Booster.

3. Plug the power supply into the Signal Booster input marked “6V DC”

(carefully, to avoid damaging the center pin) and then into a wall outlet.

Note:

Wilson

Electronics recommends that all AC power supplies for

home electronics be plugged into a Surge Protector Power Strip.

4. If the Signal Booster does not have a green light(s), please see pages 10-

12. See page 12 for AG Pro Installer.

5. If you know that only one frequency band (800 or 1900) is available in

your coverage area (or going to be used), reduce the gain control on the

frequency band that is NOT in use to the lowest setting. This will reduce

the power consumption of the Signal Booster.

6. Using multiple Signal Boosters in one installation could cause interference

to the cell tower (except for the In-Line Signal Booster).

Contact Wilson Electronics Technical Support Team with any questions at

866-294-1660 or email [email protected]. Technical Support

hours are Mon.- Fri. 7 am to 6 pm MST.

Installing a Wilson Electronics Signal Booster

Select a location to install the Signal Booster that is away from excessive

heat, direct sunlight, moisture and that has proper ventilation. Do not

place the Signal Booster in an air-tight enclosure. Recommended

installation locations for in-building Signal Boosters are near a power

outlet and in a closet or on a shelf.

Note: It is important to have adequate air ventilation. Maintain at least 6

inches of clearance from surrounding objects. Be careful when

plugging the connector in so as not to damage the center pins on

the connectors.

Run the Outside Antenna cable to the Signal Booster and attach it to

the connector labeled “Outside Antenna” on the Signal Booster. Run the

Inside Antenna cable to the Signal Booster and attach it to the connector

labeled “Inside Antenna” on the Signal Booster.

Note:

For distances of 20 feet or more, use Wilson low loss cable.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Wilson Electronics AG Pro 70 Spécifications Page 10