Wilson Electronics AG Pro 70 Spécifications télécharger pdf (Page 11)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Point antennas away from each other

CORRECT INSTALLATION

Never point antennas toward each other

INCORRECT INSTALLATION

Figure 1

Figure 2

Signal Booster Signal Booster

Outdoor

Antenna

Outdoor

Antenna

Inside Panel

Antenna

Inside Panel

Antenna

During installation mode the Signal Booster is resetting itself very quickly

to aid the installer. The Signal Booster is equipped with two indicator

lights, one for the 800 MHz band and the other for the 1900 MHz band.

For the first 15 minutes that the Signal Booster is plugged in, it is for a

test and alignment period. During this time, both lights will do one of the

following 4 things:

1. BLINKING GREEN

If the Signal Booster is blinking green, the Signal Booster is operating

properly. If you are happy with the coverage area in your building, then

you are done. Blinking will stop after the 15 minute installation period.

2. BLINKING ORANGE

Note: For AG Pro Installer see additional instructions on page 12.

If either of the two lights on the Signal Booster are blinking orange

the Signal Booster is experiencing receiver overload. The Signal

Understanding the Signal Booster Lights and

Troubleshooting

Note: If after the initial 15 minutes you are not done with the installation,

the Signal Booster can be reset and enter installation mode again

by disconnecting and reconnecting the power supply from the

Signal Booster.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Wilson Electronics AG Pro 70 Spécifications Page 11