Wilson Electronics AG Pro 70 Spécifications télécharger pdf (Page 8)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Signal readings usually appear as a negative number (for example, -86).

The closer you get to zero the stronger the signal (see graph above).

-50dB -60dB -70dB -80dB -90dB -100dB -110dB

EXCELLENT GOOD POOR NO

SIGNAL

Signal Strength Graph

Cell Tower

Cell Signal

Outside

Wide Band

Antenna

Mounting Tips for Running Outside

Antenna Cable

If you are mounting the Outside Antenna on the roof of your building, we

have found that it is easiest to run your cable underneath the down side

of your roof’s flashing. If you have satellite TV service installed you may

be able to follow the same route as the satellite TV cables that are already

running from outside of your building to the inside.

After routing the cable, we recommend sealing any areas where the cable

passes into the building with cable bushings, silicone or other waterproof

sealant to keep your installation from leaking. If you are mounting the

Outside Antenna to the outside wall of your home or building, the simplest

way is to run the cable on the outside of the wall and attach it to the

exterior of your home or office. Then drill a hole through the wall where you

want the cable to appear on the inside of the building. Before drilling, make

sure that there are no electrical outlets, sewer or water pipes, or electrical

wiring in the wall that you are about to drill through as this could potentially

harm you or damage the building.

you to read the signal strength from the cell tower. It is preferable to have

the phone in the test mode so the actual signal strength can be read,

as bars are not the most accurate. Go to www.WilsonElectronics.com

for help in finding the test mode for your phone. Always make sure the

person inside the building gives the signal time to arrive and register

on the phone (between 10-30 seconds for phone to reset to the signal

reading).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Wilson Electronics AG Pro 70 Spécifications Page 8