Wilson Electronics AG Pro 70 Spécifications télécharger pdf (Page 9)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Installing the Inside Antenna

(Instructions are for optional Panel Antenna)

Select a location for the Inside Antenna, preferably in the center of where

the signal needs to be amplified. A minimum separation distance of 20

vertical feet is necessary for operation. If the inside coverage is not

sufficient you may need as much as 75 feet of horizontal separation. See

installation diagram on pages 3 & 4.

Ceiling

Rafters

Ceiling

Drywall

Inside

Antenna

After drilling the required hole, run the cable through and seal it with cable

bushings, silicone or other waterproof sealant to enclose the hole that you

have created. In some instances, it may be possible to run the cable up

into the fascia of the attic overhang. In this circumstance, the cable will be

accessible in the attic for further routing.

In some cases, multiple Inside Antennas may be required, for instance if

you have multiple rooms with poor signal. A signal may be split by using

a splitter (sold separately). If using more than one Inside Antenna, a

separation up to 75 horizontal feet may be necessary between Inside

Antennas. See configuration on pages 3 & 4.

3-way

(859980)

4-way

(859981)

2-way

(859957)

(sold separately)

Splitter Options:

Warning: An Inside Antenna must have a separation distance from all

persons that is at least 15 inches for the Panel Antenna.

Optional Wide

Band Inside

Antenna (sold

separately)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Wilson Electronics AG Pro 70 Spécifications Page 9