Wilson Electronics AG Pro 70 Spécifications télécharger pdf (Page 6)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Reasons for Weak Cellular Signals

Anyone who uses a cell phone or cellular data card knows the frustration

of not being able to connect to or maintain a strong cellular signal. When

this occurs, it is generally due to one of two reasons:

Location of the Nearest Cell Tower – Cell towers are situated to 1.

provide broad coverage; however, there are many areas in which

signal strength may be reduced by topographic features or by local

government restrictions on the height or placement of the towers

themselves. Rural areas generally have fewer cell towers than urban

regions.

Natural and Man-Made Obstructions – Signal strength can also 2.

be negatively affected by trees, hills, buildings, weather, and other

obstructions. You may be relatively close to a cell tower but still unable

to make a call. This often occurs in homes, offices and other buildings

in which stucco, concrete or metal walls may block the signal.

The Signal Booster works with two antennas. The Inside Antenna

communicates with your cell phone and the Outside Antenna

communicates with the cell tower. The Outside Antenna receives the cell

tower signal and sends it through the cable to the Signal Booster, where it

is amplified and re-transmitted much stronger through the Inside Antenna

into the room. When the Inside Antenna picks up a signal from your

cellular device, the Signal Booster amplifies that signal and transmits it

through the cable to the Outside Antenna and back to the cell tower.

Note: The Signal Booster will only operate if there is an adequate signal

to amplify.

Cell Tower

The antenna should be mounted as shown in the illustration above.

The mounting bracket, included with antenna, is adjustable and will

accommodate pipe diameters from 1.25” to 2” (pipe sold separately part#

901117). Mount the antenna so that there is at least 3 feet of clearance in

all directions around it. Position the antenna so that it has an unobstructed

line of sight to the cell tower’s strongest signal. Make sure the antenna

is not pointing across your own roof or at the Inside Antenna as this will

cause the oscillation protection circuitry to shut down the Signal Booster

(see page 10).

Outside Antenna Installation (part #304411 shown)

Drip hole on bottom

Cell Tower

Antenna

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Pas de commentaire

Wilson Electronics AG Pro 70 Spécifications Page 6