Wilson Electronics SignalBoost DT Guide d'installation télécharger pdf (Page 10)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Hours: 7 am to 6 pm MST.

Installing the Inside Antenna for DB Pro

Find the desired location for the inside panel antenna. Verify that the

inside panel antenna and the outside antenna have the necessary

separation (Minimum of 15 vertical/horizontal feet if installed with

signal booster set at a lower gain, for maximum gain you may need

as much as 50 feet of separation). For optimum results the antenna

should be mounted at least 6 feet off the ground.

Inside

Antenna

Ceiling

In some cases, multiple inside antennas may be required if you

have multiple rooms with poor signal. A signal may be split by

using a splitter. See configuration on pages 3 & 4. Wide Band

Panel Inside Antenna (Included in some kits)

Wide Band

Panel Inside

Antenna

(Included in

some kits)

Warning: There must

be at least a 15 inch

separation distance

between the inside

antenna and all

persons.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Wilson Electronics SignalBoost DT Guide d'installation Page 10