Wilson Electronics SignalBoost DT Guide d'installation télécharger pdf (Page 3)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Hours: 7 am to 6 pm MST.

Select a location to install the signal booster that is away 1.

from excessive heat, direct sunlight, moisture and has proper

ventilation. Do not place the signal booster in an air-tight

enclosure.

Select a location on the roof of the building to install the outside 2.

antenna. Use a cell phone in test mode to find the strongest signal

from the cell tower. Visit

www.WilsonElectronics.com

to find test

mode function for your particular cell phone or see page 8.

Select a location for the inside antenna, preferably in the 3.

center of where the signal needs to be amplified. A minimum

separation distance (combined vertical/horizontal) of 15

feet is necessary for operation. If the inside coverage is not

sufficient you may need as much as 50 feet of separation. See

installation diagram on pages 3 & 4.

Run the outside antenna cable to the signal booster and attach 4.

it to the connector labeled “outside antenna” on the signal

booster. Run the inside antenna cable to the signal booster

and attach it to the connector labeled “inside antenna” on the

signal booster.

Before powering up the signal booster, verify that both the 5.

outside antenna and the inside antenna are connected and

check that all connections are tight. Lightning surge protection

is recommended for all in-building installations. See page 7.

Note: Be careful when plugging the connectors in so as not to

bend the center pins on the connectors.

See page 10 for more

information.

The Signal Booster has been packaged with the gain control 6.

knobs adjusted to the highest gain position. If one or both of

the lights are not green please refer to pages 13 &14.

Warning: 7.

Connecting the signal booster directly to a cell phone

with use of an adapter will damage the cell phone and the

signal booster.

Quick Install Overview

See Installation Diagram on pages 3 & 4. Contact Wilson Electronics

Technical Support Team with any questions at 866-294-1660.

1 2 3 4 5 6 7 8 ... 19 20

Pas de commentaire

Wilson Electronics SignalBoost DT Guide d'installation Page 3