Wilson Electronics SignalBoost DT Guide d'installation télécharger pdf (Page 11)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Hours: 7 am to 6 pm MST.

Installing a Wilson Electronics Signal Booster

Select a location to install the signal booster that is away from

excessive heat, direct sunlight, moisture and that has proper

ventilation. Do not place the signal booster in an air-tight

enclosure.

Recommended installation locations for in-building signal boosters

are:

• On a shelf

• In a closet

• Near a power outlet.

Note: It is important to have adequate air ventilation. Maintain

at least 6 inches of clearance from surrounding objects. Run the

outside antenna cable to the signal booster and attach it to the

connector labeled “outside antenna” on the signal booster. Run

the inside antenna cable to the signal booster and attach it to the

connector labeled “inside antenna” on the signal booster.

Note: Be careful when

plugging the connector in to

avoid bending the center pins

on the connectors.

DB Pro™

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Wilson Electronics SignalBoost DT Guide d'installation Page 11