Wilson Electronics SignalBoost DT Guide d'installation télécharger pdf (Page 8)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Hours: 7 am to 6 pm MST.

Installing Lightning Protection

Install the Lightning Surge Protector

(LSP) close to the signal booster. Attach

the cable from the outside antenna to the

surge protector. Using a short length of

low loss cable, attach one end to the LSP

and the other to the outside antenna.

Ensure the LSP is properly grounded.

(For RG6 cable use #859988-75 Ohm).

(For Wilson 400, RG-58, RG-174 cable

use #859902-50 Ohm, shown in picture).

From the

outside

antenna

Ground Wire

Lightning Surge

Protection

To the Signal Booster

Note: Use the directions included with your choice of antenna,

the instructions here are meant for the Wide Band Antenna option

shown above. The antenna should be mounted as shown in the

illustration above. The included mounting bracket is adjustable

and will accommodate pipe diameters from 1.25” to 2” (pipe sold

separately). Mount the antenna so that there is at least 3 feet of

clearance in all directions around it. Position the antenna so that

it has an unobstructed line of sight to the cell tower’s strongest

signal. Make sure the antenna is not pointing across your own roof

or at the inside antenna as this will cause the oscillation (feedback)

protection circuitry to shut down the signal booster. See page 12.

Warning:

Lightning protection is recommended for all installations.

(Part# 859988). Take extreme care to ensure

that

neither you nor the antenna comes near any electric power lines.

Cell Tower

Drip hole on bottom

Cell Tower

Wide Band Antenna option shown

Outside Antenna Installation

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Wilson Electronics SignalBoost DT Guide d'installation Page 8