Wilson Electronics SignalBoost DT Guide d'installation télécharger pdf (Page 12)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Hours: 7 am to 6 pm MST.

Powering up a Wilson Electronics Signal Booster

Never point the front of a directional outside antenna toward the 1.

inside antenna. See Figure 2 on page 12.

Ensure that both the outside antenna coax cable and the inside 2.

antenna coax cable are connected to the signal booster and the

connections are tight before powering up the signal booster.

Plug the 6-volt power supply into the signal booster input 3.

marked “POWER” (carefully, to avoid damaging the center pin)

and then into a wall outlet.

If the signal booster does not have a green light, please see 4.

pages 13 & 14.

If you know that only one frequency band (800 or 1900) is 5.

available in your coverage area (or going to be used), reduce

the gain control on the frequency band that is NOT in use to the

lowest setting. This will reduce the power consumption of the

signal booster.

Using multiple signal boosters in one installation may cause 6.

interference to the cell tower.

Contact Wilson Electronics Technical Support Team with any 7.

questions at 866-294-1660 or email tech@wilsonelectronics.com.

Technical Support hours are 7 am to 6 pm MST.

DB Pro™

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Wilson Electronics SignalBoost DT Guide d'installation Page 12